Schmid Watson User Manual

Watson-Ethernet-Manual.doc
Version 3.3-01
Watson Ethernet
Operating Manual
Revision: 2010-01-20
7-15
frames (configurable using QMAP IEEE).
PROVIDERTAG Bridge-Port Mode
Set provider tag on/off (stacked VLAN operation) on a bridge port.
Bridge-Port
One of the bridge ports (ETH, DSL)
Mode
Provider tag mode (ON, OFF)
If set to ON then an additional tag (S-Tag) will be added to Ethernet packets. The
value of the tag is determined by the DEFAULTVLAN setting of this port. The
TPID used in the outer tag is defined by the TPID setting.
TPID Bridge-Port tpid
Set provider tag TPID on a bridge port.
Bridge-Port
One of the bridge ports (ETH, DSL)
tpid
TPID (0 .. FFFFH)
7.2.10 Class of Service Configuration (Plug-in)
PRIOSRC Bridge-Port Priority-Source
Determines how packets are prioritized by the bridge:
Bridge-Port
One of the bridge ports (ETH1 .. ETH4, DSL1 .. DSL4)
Priority-Source
Priority source. Possible values:
IP Use the IP TOS/DSCP bits to deter-
mine priority
IEEE Use the IEEE 802.1p priority bits to
determine priority
IPTHENIEEE Use IP TOS/DSCP bits if present, IEEE
802.1p bits otherwise
IEEETHENIP Use IEEE 802.1p bits if present, IP
TOS/DSCP bits otherwise
STATIC Set priority bits to the default priority of
the ingress port. The default priority is
set with the DEFAULTVLAN command,
cf. 7.2.8.

Schmid Watson Specifications

General

Brand	Schmid
Model	Watson
Category	Network Router
Language	English