802.1p bits otherwise
IEEETHENIP Use IEEE 802.1p bits if present, IP
TOS/DSCP bits otherwise
STATIC Set priority bits to the default priority of
the ingress port. The default priority is
set with the DEFAULTPRIO command,
cf. 7.2.9.
Several Codepoints can be associated to a queue with a single command, e.g.
NTU_CM> QMAP IEEE Q2 3 4 5
results in all packets with IEEE 802.1p priority bit combinations 011, 100 and
101 to be sent to queue 2.
QMAP without parameters displays the current CoS configuration:
NTU_CM> QMAP
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Bridge IEEE Priority Mapping:
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
0 : Q2 | 1 : Q1 | 2 : Q1 | 3 : Q2 | 4 : Q3 | 5 : Q3 | 6 : Q4 | 7 : Q4 |
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Bridge DSCP Priority Mapping:
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
0 : Q1 | 1 : Q1 | 2 : Q1 | 3 : Q1 | 4 : Q1 | 5 : Q1 | 6 : Q1 | 7 : Q1 |
8 : Q1 | 9 : Q1 | 10 : Q1 | 11 : Q1 | 12 : Q1 | 13 : Q1 | 14 : Q1 | 15 : Q1 |
16 : Q2 | 17 : Q2 | 18 : Q2 | 19 : Q2 | 20 : Q2 | 21 : Q2 | 22 : Q2 | 23 : Q2 |
24 : Q2 | 25 : Q2 | 26 : Q2 | 27 : Q2 | 28 : Q2 | 29 : Q2 | 30 : Q2 | 31 : Q2 |
32 : Q3 | 33 : Q3 | 34 : Q3 | 35 : Q3 | 36 : Q3 | 37 : Q3 | 38 : Q3 | 39 : Q3 |
40 : Q3 | 41 : Q3 | 42 : Q3 | 43 : Q3 | 44 : Q3 | 45 : Q3 | 46 : Q3 | 47 : Q3 |
48 : Q4 | 49 : Q4 | 50 : Q4 | 51 : Q4 | 52 : Q4 | 53 : Q4 | 54 : Q4 | 55 : Q4 |
56 : Q4 | 57 : Q4 | 58 : Q4 | 59 : Q4 | 60 : Q4 | 61 : Q4 | 62 : Q4 | 63 : Q4 |
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NTU_CM>
RATELIMIT CIR CBR
Configures the ingress rate limiter of the Ethernet port.