Schmid Watson User Manual

Watson-Ethernet-Manual.doc
Version 3.3-01
Watson Ethernet
Operating Manual
Revision: 2010-01-20
7-29
STATUS ETH
STATUS ETH displays status information of the Ethernet bridge interfaces:
LTU_01_FMM> STATUS ETH
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Status of the bridge's Ethernet interfaces
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Port AdminStatus Mtu OperStatus Speed Dup Flow
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
ETH1 up 1536 down 0 b/s auto auto
ETH2 up 1536 down 0 b/s auto auto
ETH3 up 1536 down 0 b/s auto auto
ETH4 up 1536 down 0 b/s auto auto
DSL1 up 1536 up 100 Mb/s auto on
DSL2 up 1536 up 100 Mb/s auto on
DSL3 up 1536 up 100 Mb/s auto on
DSL4 up 1536 up 100 Mb/s auto on
MGMT3 up 1536 down 0 b/s auto off
Port
The bridge port
AdminStatus
Administrative state
Mtu
Maximum frame size
OperStatus
Operating state
Speed
Interface speed. Note that for ports DSL1 .. DSL4 this is
the internal speed between the Ethernet bridge and the
DSL processor, not the DSL sync rate. Cf. Figure 3-4
Dup
Duplex mode
Flow
Flow control

Schmid Watson Specifications

General

Brand	Schmid
Model	Watson
Category	Network Router
Language	English