SCHUNK CMS 050 - 2 Basic safety notes; 2.1 Intended use; 2.2 Not intended use

Basic safety notes
8 01.00 | CMS | Assembly and operating manual | en | 1553577
2 Basic safety notes
2.1 Intended use
l
The manual change system CMS consisting of a manual change
head CMS-K and a manual change adapter CMS-A is intended
for rapid changing of parts and automation components, e.g.
grippers on a robot.
l
The manual change system CMS is not part of the load.
l
The manual change head CMS-K is mounted on an industrial
robot. The manual change adapter CMS-A is mounted on the
end effector.
l
CMS-A and CMS-K are connected with a quick-release system.
l
Connection of optional modules to head and adapter and
inductive sensors to head (not with basic version).
Operating conditions
l
Use in covered or closed areas
l
Use in non-explosive areas
l
Pass through air only. No corrosive and flammable gases
permitted.
l
The product may only be used within the scope of its technical
data, }3 [/15].
l
The product is intended for industrial and industry-oriented
use.
l
Appropriate use of the product includes compliance with all
instructions in this manual.
2.2 Not intended use
Any use that exceeds or differs from the appropriate use is
regarded as misuse. This includes in particular:
l
Use of the CMS as lifting equipment
l
Outdoor use
l
Use in potentially explosive areas