SCHUNK OSE - Page 39

Maintenance
Disassembly of the
shock absorbers
1. Remove cover (3).
2. Remove the safety ring (86).
3. Take off the shock absorber (30) with the adjusting washer
(93/94).
Assembly is done in reverse order
5.4.3 OSE 57
Disassemble 1. Remove air connections.
2. Remove covers (3, 4).
3. Mark positions of pinion (14/15) and the piston (2). For
versions with air passage, mark also the rotary transmission
leadthrough (17).
4. Disassemble the distribution flange (17) and the safety ring
(85).
5. Draw pinion (14/15) out of housing.
6. Push piston (2) out of housing.
7. Remove all seals.
Disassembly of the
shock absorbers
1. Remove cover (3).
2. Remove the safety ring (86).
3. Take off the shock absorber (30) with the adjusting washer
(93/94).
Assembly is done in reverse order
5.4.4 OSE 63
Disassemble 1. Remove air connections.
2. Remove covers (16, 11).
3. Mark positions of pinion (2) and the piston (5). For versions
with air passage, mark also the rotary transmission
leadthrough (3).
4. Remove the piston (5) on one side.
5. Remove distributor flange (3) and circlip (52).
6. Draw pinion (2) out of housing.
7. Push piston rod (30) and piston (5) out of housing.
8. Remove all seals.
Disassembly of the
shock absorbers
1. Loosen lock nut (54).
2. Screw the shock absorber (32) together with the seal (49) out
of the adjustment sleeve (10).
3. Screw the new shock absorber (32) into the adjustment sleeve
(10) until it stops.
4. Position the O-ring (49) and tighten the lock nut (54).
3903.00 | OSE | Assembly and Operating Manual | en | 1373804