Maintenance
5 Maintenance
5.1 Maintenance and lubrication intervals
CAUTION
Material damage due to hardening lubricants!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
• Reduce the lubricant intervals accordingly.
Maintenance- and lubrication interval
Designation Swivel Unit EDF
Interval [Mio. cycles] 2 2
5.2 Lubricants/Lubrication points (basic lubrication)
SCHUNK recommends the lubricants listed.
During maintenance, treat all greased areas with lubricant. Thinly
apply lubricant with a lint-free cloth.
Lubricant point Lubricant
The teeth and the pinion Toothgood 1
All seals Rivolta F.L.G. GT-2
Metallic sliding surfaces Renolit HLT 2
3503.00 | OSE | Assembly and Operating Manual | en | 1373804
To Next Page
Loading...
