SCHUNK OSE - Mounting and Connecting

Assembly and settings
26 03.00 | OSE | Assembly and Operating Manual | en | 1373804
4.3 Mounting and connecting
CAUTION
Risk of damage to the product!
If the end position is approached too hard, the product may be
damaged.
• As a rule, a rotary movement must take place without impact
and bouncing.
• To do this, carry out sufficient throttle and dampening.
• Observe specifications in the catalog data sheet.
CAUTION
Material damage due to opened exhaust air throttle valves!
If during first actuation the exhaust throttle valves are open, the
product may move in an uncontrolled manner.
• Close the exhaust air throttle valves completely before
applying pressure.
1. Screw on swivel unit, }4.1 [
/
18].
✓ Zentrierhülsen verwenden.
✓ Anzugsdrehmoment der Befestigungsschrauben beachten,
siehe Tabelle Anzugsdrehmoment.
2. Screw the mounting part to the pinion using two dowel pins
and two mounting screws, }4.1 [
/
18].
3. Screw throttles into air connections A and B and connect
compressed air lines.
4. Screw screw plugs into any open and unused air connections
5. Adjust the of swivel angle, }4.4 [
/
27].
6. Connect sensors, if necessary, }4.6 [
/
32].