SCHUNK OSE - Adjusting of Swivel Angle; Ose 22-57

Assembly and settings
4.4 Adjusting of swivel angle
Position of the item numbers, }5.6 [
/
41].
4.4.1 OSE 14
Adjustment of the end positions
1. Set connection A under pressure until product unit reaches its
end position.
2. Loosen counter-nut (72) at B and turn back stop screw (5) until
the desired end position is reached.
3. Fasten counter-nut (72) and check end position.
4. Repeat same procedure for 2nd end position.
Adjustment of the 90° intermediate position
1. Loosen the counter-nuts (73) and slightly turn back the spindle
(13).
✓ Das Ritzel hat in der Zwischenstellung Luft.
2. Actuate connection A until the produkt reaches its end
position.
3. Adjust the intermediate position with the spindle (13) at A and
fasten the counter-nut (73).
4. Check the adjustment by first actuating connection A and then
the connection for the intermediate position. Actuate until the
end position is reached.
5. Repeat same procedure for intermediate position B.
6. After adjustment, the rack must not have any more clearance.
NOTE
If the counter-nut (73) is loose, air may stream out of the spindle
(13). This is due to design and no defect.
2703.00 | OSE | Assembly and Operating Manual | en | 1373804