Maintenance
40 03.00 | OSE | Assembly and Operating Manual | en | 1373804
5.5 Servicing and assembling the product
Maintenance • Clean all parts thoroughly and check for damage and wear.
• Replace all wear parts / seals.
• Treat all greased areas with lubricant.
Assembly • Assembly takes place in the opposite order to disassembly
Carefully assemble the rotary transmission lead through and
make sure that no O-rings will be damaged.
• Unless otherwise specified, secure all screws and nuts with
Loctite no. 243 and tighten with the appropriate tightening
torque.
To Next Page
Loading...
