7.44
SEL-700G Relay Instruction Manual Date Code 20170814
Communications
SEL ASCII Protocol and Commands
STATUS Command (Relay Self-Test Status)
The STA command (see Table 7.50) displays the status report.
Refer to Section 10: Testing and Troubleshooting for self-test thresholds and
corrective actions, as well as hardware configuration conflict resolution.
Table 7.51 shows the status report definitions and message formats for each test.
RTD Settings
E49RTD := NONE
X Side SyncCheck
E25X := N
Y Side SyncCheck
E25Y := N
Demand Mtr Set
EDEM := ROL DMTC := 15 PHDEMPX := 5.00
GNDEMPX := 1.00 3I2DEMPX := 1.00 PHDEMPY := 5.00
GNDEMPY := 1.00 3I2DEMPY := 1.00
X Side Pole Open
50LXP := 0.25 3POXD := 0.00
Y Side Pole Open
50LYP := 0.25 3POYD := 0.00
Trip/Close Logic
TDURD := 0.50 CFDX := 0.50 CFDY := 0.50
TRX := SV06 OR SV07 OR SV08 OR 46Q2T OR 81X1T OR 81X2T OR 81RX1T OR 81RX2T
OR NOT LT02 AND SV04T OR OCX
TR1 := SV06 OR SV07 OR SV08
TR2 := SV06 OR SV07 OR LT06
TR3 := SV06 OR SV07
TRY := SV09 OR SV10 OR LT02 AND SV04T OR OCY
REMTRIP := 0
ULTRX := 3POX
ULTR1 := NOT TR1
ULTR2 := NOT TR2
ULTR3 := NOT TR3
ULTRY := 3POY
52AX := 0
CLX := SV03T AND NOT LT02 OR CCX
ULCLX := TRIPX
52AY := 0
CLY := SV03T AND LT02 OR CCY
ULCLY := TRIPY
=>>
Figure 7.26 SHOW Command Example (Continued)
Table 7.50 STATUS Command (Relay Self-Test Status)
Command Description Access Level
STA n Display the relay self-test information n times
(n = 1–32767). Defaults to 1 if n is not specified.
1
STA S Display the memory and execution utilization for
the SEL
OGIC control equations.
1
STA C or R Reboot the
relay and clear self-test warning and
failure status results.
2
Table 7.51 STATUS Command Report and Definitions (Sheet 1 of 2)
STATUS Report Designator Definition Message Format
Serial Num Serial number Number
FID Firmware identifier string Text Data
CID Firmware checksum identifier Hex
PART NUM Part number Text Data
To Next Page
