SEA PUSH User Manual

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
PUSH
TABLE OF CONTENTS
INTRODUCTION.........................................................................................................................................................30
FEATURES..................................................................................................................................................................30
SPECIFICATIONS.......................................................................................................................................................30
INSTALLATION............................................................................................................................................................31
Precautions......................................................................................................................................................31
Package Contents............................................................................................................................................31
CONNECTION TERMINALS.......................................................................................................................................31
The On-Board LED Indicators...........................................................................................................................33
The Pacier Tones & The LED Signals................................................................................................................33
The Jumper for Back-Lit Selection....................................................................................................................33
FEATURE PROGRAMMING & OPERATION INSTRUCTIONS...................................................................................34
Set System in Programming Mode with The Master Code.................................................................................34
Direct Access to Programming Mode with The “DAP” Code – 8 0 8 0..................................................................34
Refresh The System with The “Refreshing Code” --- 9 9 9 9...............................................................................35
The Default Values of The Keypad....................................................................................................................35
KEYPAD PROGRAMMING MAKE SIMPLE – For General Users.................................................................................36
FEATURE PROGRAMMING -- KEY IN AND STORE THE DESIRED VALUES.............................................................37
Programming Criteria for Codes.......................................................................................................................37
Record A Master Code......................................................................................................................................38
Record A Super User PIN..................................................................................................................................38
Operation And Functions of The Super User PIN...................................................................................38
Record-Delete PINs for Output 1, 2, & 3............................................................................................................39
Examples – Programming And Operation.............................................................................................39
Visitor Codes (For Output 1 Only).....................................................................................................................41
Duress Codes (For Outputs 1, 2 & 3).................................................................................................................42
The Operation And Function of The Duress Code.................................................................................43
Conguration of The Output Modes for Output 1, 2 And 3....................................................................................43
Personal Safety And System Lock-Out.............................................................................................................43
User PIN Entry Mode........................................................................................................................................44
Pacier Tones On-Off Selection..........................................................................................................................44
Output Operation Announcer............................................................................................................................44
Status LED Flashing On-Off during Standby......................................................................................................45
Door Forced Open Warning & Timing................................................................................................................45
Door Propped-Up Warning & The Delay Time...................................................................................................45
Intelligent Egress Button – An Unique Feature of A Contemporary Keypad........................................................46
Egress Delay , Warning And Alarm....................................................................................................................46
Congurations of The Egress Warning And Alarm...................................................................................46
Door Opening Alarm & Timer.............................................................................................................................47
Close The Programming Mode.........................................................................................................................48
PROGRAMMING SUMMARY CHART.........................................................................................................................48
APPLICATION EXAMPLES.........................................................................................................................................50
Basic Wirings of A Stand Alone Door Lock.........................................................................................................50
Basic Wirings of A Stand Alone Door Lock with Inhibit Authorization Code.........................................................51
Basic Wirings of An Inter-Lock System Using Two Keypads..............................................................................52
APPLICATION HINTS FOR THE AUXILIARY TERMINALS..........................................................................................53
APPENDIX...................................................................................................................................................................55
English
29Rev. 01 - 05/201167411245

SEA PUSH Specifications

General

Brand	SEA
Model	PUSH
Category	Keypad
Language	English

Summary

CONNECTION TERMINALS

FEATURE PROGRAMMING AND OPERATION INSTRUCTIONS

ACCESSING PROGRAMMING VIA MASTER CODE

Step-by-step guide to enter programming mode using the Master Code.

DIRECT ACCESS TO PROGRAMMING VIA DAP CODE 8080

Alternative method to enter programming mode using the DAP code when Master Code is forgotten.

SYSTEM REFRESH AND DEFAULT VALUES

FEATURE PROGRAMMING: KEY IN AND STORE VALUES

MASTER CODE AND SUPER USER PIN MANAGEMENT

RECORDING AND OPERATING WITH SUPER USER PINS

Details on setting, deleting, and using Super User PINs for system control and inhibition.

USER PIN MANAGEMENT: RECORD AND DELETE

DURESS CODE MANAGEMENT

DURESS CODE OPERATION AND OUTPUT MODES

PERSONAL SAFETY AND SYSTEM LOCK-OUT

USER PIN ENTRY MODES

DOOR FORCED OPEN AND PROPPED-UP WARNINGS

Configuration of warnings and timing for doors forced open or left ajar.

INTELLIGENT EGRESS BUTTON FEATURES

EGRESS DELAY, WARNING, AND ALARM CONFIGURATION

Settings for egress button behavior, including delay, warning beeps, and alarms.

DOOR OPENING ALARM AND TIMER

APPLICATION EXAMPLES: WIRING DIAGRAMS

STAND ALONE DOOR LOCK WIRING

STAND ALONE DOOR LOCK WITH INHIBIT FUNCTION

INTER-LOCK SYSTEM WIRING WITH TWO KEYPADS

Wiring diagram for implementing an inter-lock system using two keypads.