Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
PUSH
English
FEATURE PROGRAMMING - - KEY IN AND STORE THE DESIRED VALUES
The feature values can be set and stored into the system one by one with the desired Programming Locations.
Programming can be made continuously and it is not necessary to be in sequence order. Just go to the desired programming
location and key in the value for the desired feature.
IMPORTANT NOTE --- Programming Criteria for Codes:
a) The User PINs and Codes:
All the User PINs, Master Code, Duress Codes, Super User PIN and the Visitor User Codes are Prime Codes in the system.
They MUST be unique and can not be repeated in the programming
b) Warning for A Repeated Use of Prime Code:
One long beep is given if a User Code/PIN is keyed in. It means that a Code/PIN was already in one of the PIN or Code Locations
or IDs. The programming is invalid. Change a new Code/PIN and program it again.
c) Make A List Recording of The User Names VS User Codes:
Suggest the owner to make a list recording of the User Names corresponding to the Codes/PINs that are going to store in the
Locations and the IDs before the programming. It will be a useful tool for the owner to easily program them smoothly and also to
trace them from this multi-users system in the future.
Example:
User Name Location Function Code User ID PIN/Code Remark
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
--
1,000
37Rev. 01 - 05/201167411245
To Next Page
Loading...