SEA PUSH - MASTER CODE AND SUPER USER PIN MANAGEMENT; RECORDING AND OPERATING WITH SUPER USER PINS

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
PUSH
English
RECOR A MASTER CODE ( Location 01)
LOCATION MASTER CODE VALIDATION
01 4 to 8 Digits #
MASTER CODE
• Master Code is the authorization code for setting the system to programming mode. It is NOT an User Code operating of the
output relays.
• The Master Code can be 4 to 8 digits. Press # key to confirm code entry
• When a new master code is keyed in and confirmed, the old master code is replaced automatically.
• The master code is also the Link-up Code between the keypad and the optional controller of the system in Split-decoded
operation.
• Example: Set a Master Code with the number of “2 2 3 3” ---- 01 2233 #
RECORD A SUPER USER PIN (Location 02)
The Super User PIN has TWO functions. It is prepared for the owner to simply use only one User PIN to operate the three outputs
of the keypad and make operation inhibit enable / disable to the system outputs.
LOCATION SUPER USER PIN VALIDATION
02 4 to 8 Digits #
SUPER USER PIN
• The Super User PIN can be 4 to 8 digits.
• Two beeps will be heard after pressing the # key to confirm code entry.
• When a new Super User PIN is keyed in and confirmed, the old one is replaced.
• Example: Set a Super User PIN with the number of “2580” ----02 2580 #
• To deleted a Super User PIN from memory: Key in just the Location number and #. ----0 2 #
OPERATION AND FUNCTIONS OF THE SUPER USER PIN
1) Operate Output 1, 2, and 3
The operation of the Super User PIN is just like a normal User PIN. Simply key-in the PIN with a specic output number for the
desired Output. The Super User PIN can also be used to reset an operating output timer instantly.
SUPER USER PIN # 1 -------- Output 1 Activates or Output 1 Resets
SUPER USER PIN # 2 -------- Output 2 Activates or Output 2 Resets
SUPER USER PIN # 3 -------- Output 3 Activates or Output 3 Resets
2) Inhibit The User PINs For Output 1
The Super User PIN can also be used to inhibit the normal User PINs for the Output 1 (usually they are for door strike). It enhances
the security level of the access control system, such as to stop a keypad after office hour or while the house is nobody inside. Once
the Output 1 is inhibited, the User PINs for it become invalid and those people even know the User PINs are refused during the
system is inhibited. The inhibit function is toggled in Start / Stop mode with the following code entry.
SUPER USER PINI # 9 -------- The Whole Group of User PINs for Output 1 are Disabled or Enabled in Toggle
NOTE:
• The inhibit function setting with the Super User PIN applies to the whole group of User PINs for Output 1 ONLY , but not for Output
2 or Output 3.
• For safety reason, the inhibit function initiated with the Super User PIN does not govern the Egress Button. The door still can be
opened with it from inside.
• The Super User PINs are always valid. They are not governed by any inhibit or lock-out function in the system.
38 Rev. 01 - 05/201167411245