SEA PUSH - KEYPAD PROGRAMMING MAKE SIMPLE

To Next Page

To Previous Page

Sistemi Elettronici

di Apertura Porte e Cancelli

International registered trademark n. 804888

PUSH

English

KEYPAD PROGRAMMING MAKE SIMPLE – FOR GENERAL USERS

This is a multi purpose keypad. It has many functions for user’s selection. For those general users taking the keypad for door strike

only, most of the features can be kept in their Default values. Only the User PINs and a private Master Code are necessary to

program for the system.

PROGRAMMING

NOTE:

a) The * button is equivalent to the button in the keypad with bell button.

b) Wait 1 minute until the end of the power up delay.

1) Set System into Programming Mode with The Factory Set Master Code 0000

0000 ** --- - 2 beeps, system is inP rogramming Mode.

NOTE: If the Master Code is forgotten, use the DAP Code to set the system into programming mode. See DAP CODE 8080 on the

previous page for the details.

2) Change The Factory Set Master Code to Owner’s Private Master Code for Security Reason

01 32 89 # ---- 2 beeps, 3 2 8 9 is a Master Code for example here only 3289 is the new Master Code and the 0000 is

erased

3) Set an “User PIN” to Operate The Output 1 for Door Open

10 2 001 8321 #

(a ) (b) (c) (d) (e)

(a) 10 = Programming Location for Output 1

(b) 2 = Programming for User PIN

(d) 8321 = The User PIN that is programmed for door open. 8321 is an User PIN for example here only

(e) # = Conrm the User PIN, 2 beeps

REMARK:

If more User PINs are required for Output 1, repeat the procedures (3) above with other User IDs, such as 002, 003, 004 --- 999 etc.

Total 1000 users are allowed. See Programming Location 10 for the details.

4) Close The Programming Mode

** ---- 2 beeps

The programming mode is closed. The keypad is back to normal operation mode.

OPERATION

5) Open The Door with The User PIN

8321 # ---- 2 beeps, the door is open

REMARK:

In the next Section, “KEY IN AND STORE THE DESIRED VALUES” describes all the features and functions of the system in detail.

Users can follow them to tailor the desired values for their access control system. Suggest the general users also spend some time

on them to get acquaint with this powerful system for future expansion.

36 Rev. 01 - 05/201167411245

SEA PUSH - KEYPAD PROGRAMMING MAKE SIMPLE - for General Users