Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
PUSH
English
FEATURE PROGRAMMING & OPERATION INSTRUCTIONS
SET SYSTEM INTO PROGRAMMING MODE WITH THE MASTER CODE
IMPORTANT NOTE:
1) DO NOT TURN OFF POWER while the keypad is in Programming Mode. Otherwise, it may cause data lost/error programmed
features in the memory.
2) The keypad beeps after power up. Wait 1 minute until the end of the power up delay, then key in the Master Code for setting the
system into programming mode.
3) For the owner’s convenience in programming at the first time, the factory has put a Master Code 0000 into the keypad (It is NOT
a default code). To compromise security, in all cases, the owner should program a new Personal Master Code to invalidate the
factory set Master Code after the keypad is owned.
4) The Button * (Bell button) has two functions in the keypads with Door Bell button. It is a door bell button while the keypad is in
normal operation; and it is equivalent to a * Button in programming mode.
MASTER CODE VALIDATION
0000 **
MASTER CODE
• The Master Code can be a factory set master code or the private master code that was set by the owner.
• Validate the master code with * *
2-beep confirms a valid master code. The Mains LED (Amber) is constantly ON after the system is set in the programming mode.
DIRECT ACCESS TO PROGRAMMING MODE WITH THE “DAP” CODE – 8080
Set System Into Programming Mode With DAP Code In Case Of The Master Code Is Forgotten ! !
The owner requires to apply the following procedures precisely to set the system into programming mode with the DAP code
8080.
1) Switch OFF all the power for 1 minute to ensure that the system is fully discharged.
2) Swich ON power again. The system is in Power-up Mode for 1 minute and the buzzer gives beeps during the whole period. This
is the only time limit for setting the system to Direct Access to Programming (DAP).
3) Press the Egress Button (EG IN) once first to enable the DAP function.
4) Key in the DAP Code 8080 and validate it with * *, the existing Master Code in the memory is erased and the power up beep
stops. The keypad turns itself into programming mode like using the Master Code and it is ready to accept the new programming
data.
5) If the Egress Button is not pressed and the DAP code is not keyed in within the power up period, the system will set itself to
normal operation mode. To set it back to power-up mode, repeat procedures 1-4.
EGRESS BUTTON DAP CODE VALIDATION
8080 **
PRESS ONCE
DAP CODE
• The DAP code is xed on 8080 and it is valid only in the Power-up Period after the Egress Button is pressed.
• Validate the DAP code with the * *
• 2-beep confirms the system is in the Programming Mode; and the Mains LED is constantly ON.
• See “RECORD A MASTER CODE” at “Location 01” for the details of programming a new master code.
34 Rev. 01 - 05/201167411245
To Next Page
Loading...