Retrofitting seca 703 column scale • 85
17-10-01-266-002a/07-2018B
Depending on the installation and connection version, you may need the
following tools (not included in the scope of delivery):
2.1 Preparing the scale
1. Switch off the scale.
2. Disconnect the power supply unit from the power supply socket.
3. Pull the power cable out of the scale.
4. Remove the batteries:
a) Press the latch of the battery compartment
b) Open the lid of the battery compartment
c) Remove batteries from the battery holder
d) Put battery holder back and close lid again
5. Store the power supply unit and the batteries or dispose of them properly
(➔ Disposal).
Pos. Component Size
1
Cross-head screwdriver PH 1
2
Hex socket wrench 4.0
3
Ethernet cable n/a
To Next Page
Loading...
