Secure Liberty 100 - Changing the Alarm Suppression Period; Enabling Diagnostic Displays

Page 50 of 116
Liberty 100 Smart Electricity Meter Technical Reference Manual
BGX501-767-R02
5.20.1 Changing the Alarm Suppression Period
The following Engineering Code is used to suppress the alarm:
< 00000-0xxxx-yyyy >
Where ‘xxxx’ is replaced with the alarm suppression start time (HH:MM) and ‘yyyy’ with the alarm suppression
end time (HH:MM).
For example, the code ‘00000-02030-0630’ will suppress the alarm between 20:30 and 6.30.
5.20.2 Enabling Diagnostic Displays
A 6-digit Engineering Code which is common for all Liberty 100 meters is used to enable the meter’s diagnostic
display.
If there is no user interaction with the meter in this mode, auto scroll display will resume in the current operating
mode after the configured timeout period. See Annexe-II: Diagnostic Mode Displays for further details.