Secure Liberty 100 - Table 21: Key 6 Display in Prepayment Mode

Page 80 of 116
Liberty 100 Smart Electricity Meter Technical Reference Manual
BGX501-767-R02
Manual Display in Prepayment Mode
No key press at the end of this display sequence will
cause the auto-cycle display to resume.
Table 21: Key '6' display in Prepayment mode
Key 7: Emergency Credit status and value
A short press of key ‘7’ allows Users to see if Emergency Credit is made available to them; if available then the
following displays will allow enabling the Emergency Credit.
Title: Emergency Credit available
Followed by
Followed by
(timeout 4 secs)
The display indicates that Emergency Credit is now
available for use.
Press key ‘A’ on the meter keypad to enable
Emergency Credit or press key ‘B’ to ignore. If the
Emergency Credit offer message is not
acknowledged in 10 seconds then the display goes
into sleep mode and will return by pressing any key
on the meter’s keypad.
When Emergency Credit allowance is not made available or is enabled, a short press of key ‘7’ will initiate the
display sequence comprising Emergency Credit status and Emergency Credit balance. After each set of
information comprising a title followed by its data, either a four (4) seconds wait or short press of the key will
advance the display to the next set of information as described below.
Title: Emergency Credit status
(timeout 2 secs)
Followed by value
Or
Or
Or
The 1
st
set of displays associated with key 7
indicating the Emergency Credit status and
Emergency Credit allowance balance.
The examples indicate the following:
Emergency Credit cannot be enabled now,
Emergency Credit is enabled,
Emergency Credit is currently being used,