Secure Liberty 100 - Table 11: Key 6 Display in Credit Mode

Page 62 of 116
Liberty 100 Smart Electricity Meter Technical Reference Manual
BGX501-767-R02
Error! Not a valid result for
table Manual Display in Credit
(timeout 4 secs)
Followed by value
(timeout 4 secs)
Press key 6 to advance to the next display
The example display shows that 15.6 kWh have
been recorded in this register and 2.50 pence is the
current Rate1, Block1 cost per kWh.
Title 5: Current TOU tariff rate register for energy
export
(timeout 2 secs)
Followed by value
(timeout 4 secs)
Followed by value
(timeout 4 secs)
Press key 6 to return to the 1
st
display.
Press key B to scroll back up the display list.
No key press at the end of this display sequence will
cause the auto-cycle display to resume.
The 5
th
set displays the export TOU tariff rate register
currently applicable and its cumulative value.
The example shows that 15.6 kWh have been
recorded in this register and 2.50 pence is the
current R01 cost per kWh.
Table 11: Key '6' display in Credit mode
Key 7 and Key 8: No function allocated
For credit mode no functions are allocated to these key. A short press will display ‘Not Used’ as shown below:
Key 9: Total Import and Export registers
A short press of key ‘9’ will initiate the associated display sequence. After each set of information comprising a
title followed by its data, either a four (4) seconds wait or short press of the key will advance the display to the
next set of information as described below.