Sega MIB User Manual

• Specicationchanges(removalofequipment,conversionsandadditions)not
designatedbySEGAarenotallowed
The parts of the product include warning labels for safety, covers for personal protection, etc. It
is very hazardous to operate the product by removing parts and/or modifying the circuits. Should
doors, lids and protective parts be damaged or lost, refrain from operating the product, and
contact where the product was purchased from or the oce herein stated.
SEGA shall not be held responsible for any accidents or compensation for damage to a third
party resulting from the specications not designated by SEGA.
• Ensurethattheproductmeetstherequirementsofappropriateelectrical
specications
Before installing the product, check for electrical specications. SEGA products have a
nameplate on which the electrical specications are described. Ensure that the product is
compatible with the power supply voltage and frequency requirements of the location. Using
any electrical specications dierent from the designated specications can cause a re and an
electric shock.
• Installandoperatetheproductinplaceswhereappropriatelightingisavailable,
allowingwarninglabelstobeclearlyread
To ensure safety for the customers, labels and printed instructions describing potentially
hazardous situations are applied to places where accidents can be caused. Ensure that where the
product is operated has sucient lighting allowing the warnings to be read. If any label is peeled
o, apply it again immediately. Please place an order with where the product was purchased from
or the oce herein stated.
• Whenhandlingthemonitor,beverycareful(appliesonlytoproductswith
monitors)
Some of the monitor parts are subject to high tension voltage. Even after turning o the power,
some portions are still subject to high tension voltage. Monitor repair and replacement should
be performed only by those technical personnel who have knowledge of electricity and technical
expertise.
• Besuretoadjustthemonitorproperly(appliesonlytoproductswithmonitors)
Do not operate the product leaving on-screen ickering or blurring as it is. Using the product
with the monitor not properly adjusted may cause dizziness or a headache to an operator, a
player, or customer.
• Whentransportingorresellingthisproduct,besuretoattachthisManualtothe
product
* In the case where commercially available monitors and printers are used in this product, only the
contents relating to this product are explained herein. Some commercially available equipment
has functions and reactions not stated in this Manual. Read this Manual together with the specic
instruction Manual of such equipment.
* Descriptions herein contained may be subject to improvement changes without notice.
* The contents described herein are fully prepared with due care. However, should any question
arise or errors be found, please contact SEGA.
INSPECTIONSIMMEDIATELYAFTERTRANSPORTINGTHEPRODUCTTOTHELOCATION
Normally, at the time of shipment, SEGA products are in a status allowing for usage immediately
after transporting to the location. Nevertheless, an irregular situation may occur during
transportation. Before turning on the power, check the following points to ensure that the product
has been transported in a satisfactory status:
Are there any dented portions or defects (cuts, etc.) on the external surfaces of the cabinet?
Are castors and/or adjusters damaged?
Do the power supply voltage and frequency requirements meet with those of the location?
Are all wiring connectors correctly and securely connected? Unless connected in the correct way,
connector connections can not be made accurately. Do not insert connectors forcibly.
Do power cables have cuts and dents?
Are all accessories available?
Can all doors and lids be opened with the accessory keys? Can doors and lids be rmly closed?

Sega MIB Specifications

General

Brand	Sega
Model	MIB
Category	Arcade Game Machines
Language	English