To Next Page

To Previous Page

PRECAUTIONS REGARDING INSTALLATION LOCATION

2 PRECAUTIONS REGARDING INSTALLATION

• This product is an indoor game machine. Do not install it outside. Even indoors,

avoid installing in places mentioned below so as not to cause re, electric

shock, injury and/or malfunction:

• Places subject to rain/water leakage or places subject to high humidity, in the

proximity of an indoor swimming pool and/or shower, etc

• Places subject to direct sunlight or places subject to high temperatures, in the

proximity of heating units, etc

• Places filled with inflammable gas or vicinity of highly inflammable/volatile

chemicals or hazardous matter

• Dusty places

• Sloped surfaces

• Places subject to any type of violent impact

• Vicinity of anti-disaster facilities such as re exits and re extinguishers

• Areas where the temperature exceeds the applicable temperature (ambient

temperature) range of 5 to 30 degrees centigrade

LIMITATIONS OF USAGE

• Be sure to check the Electrical Specifications. Ensure that this product

is compatible with the location's power supply, voltage, and frequency

requirements. A plate describing Electrical Specications is attached to the

product. Noncompliance with the Electrical Specications can cause a re

and electric shock

• This product requires a breaker and earth mechanism as part of the location

facilities. Using the product without these can cause a re and electric shock

• Ensure that the indoor wiring for the power supply is rated at 15 A or higher

(AC single phase 100 V ~ 120 V area), and 7 A or higher (AC 220 V ~ 240 V

area). Noncompliance with the Electrical Specications can cause a re and

electric shock

• Be sure to use an independent power supply equipped with an earth leakage

breaker. Using a power supply without an earth leakage breaker can cause

an outbreak of re if a power surge occurs

• Putting many loads on one electrical outlet can cause generation of heat and

a re resulting from overload

• When using an extension cord, ensure that the cord is rated at 15 A or higher

(AC 100 V ~ 120 V area) and 7 A or higher (AC 220 V ~ 240 V area). Using a

cord rated lower than the specied rating can cause a re and electric shock

Sega MIB User Manual

Questions and Answers: