Sega MIB - PRECAUTIONS WHEN MOVING; MOVING THE MACHINE Instructions; Moving Safety Warnings

PRECAUTIONS WHEN MOVING THE MACHINE
29
7
● Always disconnect the power cable before moving the product. If it is moved
with the power cable connected, the cable could be damaged, causing re or
electric shock
● To move the unit over the oor, pull in the adjustors and have the castors
contact the oor. While moving the unit, be careful that the castors do not roll
over the power cord or the ground wire. If cord or wire is damaged, there could
be electrical shocks and/or short circuits
● When crossing a sloped or stepped area, disconnect the Monitor Cabinet and
Control Cabinet. If you tilt them while connected together, the connection
points may be damaged and personnel could be injured
● When tilting the Cabinet to move it across a sloped or stepped area, always
use at least two people. Attempting such an operation alone can lead to
accident or injury
● When moving the components separately, take care concerning the direction
you push the Monitor and Control Cabinet in. These elements may fall over,
causing damage or an accident
● When moving the components, do not push any of the plastic elements or
shaped parts and do not use them to pull the components along. This may
damage the parts or the surrounding parts and this could lead to accidents or
injury
● After dividing the components to move them, do not use the Control Units in the
Control Cabinet to push or pull the cabinet. This may damage or disgure these
parts and lead to malfunctions or injury
● When moving the separated components, be sure to push/pull each cabinet
lengthways. Trying to move the cabinet any other way may cause the cabinet
to topple over
7-1MOVINGTHEMACHINE
7 PRECAUTIONSWHENMOVING