Sega MIB - FIXATION TO INSTALLATION SITE; Stability Warning for Installation

24
ASSEMBLY AND INSTALLATION
6
Make sure that all the adjusters contact the oor. Otherwise the cabinet could
move, causing an accident
The product comes with castors attached at 8 locations and adjusters at 6 locations.
When the installation site has been determined, have the adjusters come in direct contact with the oor. Establish a
gap of about 5 mm between the oor and the castors and adjust the unit so that it will remain level.
6-4 FIXATION TO INSTALLATION SITE
CASTOR (8)
ADJUSTER (6)
1
Move the product to the installation site. If the product is to be installed near a wall, secure enough passage-
way space for players to access the seat. You must also secure a 15cm space between the back wall and the
back of the cabinet for ventilation.
2
Bring the adjusters into direct contact with the oor. Use a wrench to align the height of the adjusters until
the cabinet is perfectly level.
3
After setting, turn adjuster nuts upwards to tighten them and secure adjuster heights.