6
PRECAUTIONS REGARDING INSTALLATION LOCATION
22
Securing a safe area for operation as described in this Manual will ensure
safe operation for players and observers.
SEGA shall not be held responsible for damage or compensation for damage
to a third party, resulting from the failure to observe this instruction
• For safe operation, use and operate this product in an area measuring at least
2.58 m (101.5 in) in width and 2.3 m (90.5 in) in depth when the cabinet is
installed. SEGA shall not be held responsible for damage or compensation for
damage to a third party, resulting from the failure to observe this instruction
• The ceiling where this product is installed must be at least 2.53 m (99.6 in) high.
If the ceiling is too low, the heat emitted from the product may cause it to
catch on re
• Be sure to provide the sufcient space specied in this manual. Do not allow
objects to block the ventilation ports. This can cause generation of heat and a
re
• Put the cabinets close together so that people cannot get through or provide
enough space between them that people can go both ways without difculty.
If the cabinets are installed carelessly, people may bump into each other or
the cabinets when passing between them or fall down. To prevent people
from walking between them, place them 0.15 m (5.9 in) apart
• If the machine does not t through the entryway to the installation location,
do not disassemble it without first consulting the instructions. Specific tools
and adjustment procedures are required to assemble and disassemble the
mechanical parts. Attempting to assemble or disassemble the machine
without consulting the instructions may result in accidents during assembly/
disassembly, electric shock, short circuits, and/or personal injury during
operation. If the machine still does not t through the entryway after following
the procedures in this Manual, contact your retailer or the ofce listed in this
Manual
• If the machine is still too large to t through the entryway after following the
procedures listed in this Manual, do not tip the machine on its side. Attempting
to transport the machine while it is tipped on its side may cause accidents. It
may also damage or warp parts of the machine, resulting in accidents during
operation
OPERATION AREA (SINGLE CABINET)
0.15m
To Next Page
Loading...
Need help?
General
