Seintek S2800 User Manual

ii
5.1.9.
Acquiring the Waveform ..................................................................... 5-4
6. Triggering on a Waveform .......................................................... 6-1
6.1. Setting Trigger level (on NORmal trigger mode) .................................. 6-1
6.2. Making a single acquisition .................................................................. 6-1
6.3. Setting Trigger mode (Tmode) ............................................................. 6-2
6.4. Setting AUTO Trigger Level ................................................................. 6-2
6.5. Setting Normal Trigger mode ............................................................... 6-3
6.6. Setting Trigger Slope ........................................................................... 6-3
7. Storing and Recalling Screens .................................................. 7-1
7.1. Storing Screen ..................................................................................... 7-1
7.2. Recalling Screen .................................................................................. 7-2
8. Remote Interface Operations ..................................................... 8-1
8.1. USB HID Device Installation ................................................................ 8-1
8.1.1. System Requirements ........................................................................ 8-1
8.1.2. Operating System .............................................................................. 8-1
8.2. Verifying the computer's USB port ....................................................... 8-1
8.2.1. Installing the HID Device .................................................................... 8-1
8.3. To install Windows Application Software .............................................. 8-3
8.4. Running the Application Software ........................................................ 8-4
8.4.1. Oscilloscope Mode............................................................................. 8-4
9. Maintaining the test tool ............................................................. 9-1
9.1. About this Chapter ............................................................................... 9-1
9.2. Static Safe Handling ............................................................................ 9-1
9.3. Cleaning the Meter .............................................................................. 9-1
9.4. Storing the Meter ................................................................................. 9-1
9.5. Calibration ........................................................................................... 9-1
9.6. Replacing and Disposing of the Li-ION Battery ................................... 9-2
10. Automotive test setup .............................................................. 10-1
10.1. SENSOR function test ....................................................................... 10-1
10.1.1. ABS sensor ...................................................................................... 10-2
10.1.2. O2 Sensor ........................................................................................ 10-2
10.1.3. ECT Sensor ..................................................................................... 10-3
10.1.4. Fuel Temp ........................................................................................ 10-3
10.1.5. IAT Sensor ....................................................................................... 10-4
10.1.6. Knock Sensor .................................................................................. 10-4
10.1.7. TP Sensor ........................................................................................ 10-5
10.1.8. CKP MAG ........................................................................................ 10-5
10.1.9. CKP LoRes ...................................................................................... 10-6
10.1.10. CKP HiRes ....................................................................................... 10-6
10.1.11. CMP MAG ........................................................................................ 10-7
10.1.12. CMP LoRes ...................................................................................... 10-7
10.1.13. CMP HiRes ...................................................................................... 10-8
10.1.14. VSS MAG ........................................................................................ 10-8
10.1.15. VSS Digital ....................................................................................... 10-9

Seintek S2800 Specifications

General

Type	Digital Multimeter
Diode Test	Yes
Continuity Test	Yes
Data Hold	Yes
Backlight	Yes
Auto Power Off	Yes
Power Supply	9V battery
DC Current Range	0.1μA to 10A
AC Current Range	0.1μA to 10A
Display	LCD