● Speed Dial
● Turn on/off FM tuner
4.2 Powering On and Off
4.2.1 Headset
To power on the headset, press the Center Button and the (+) Button at the same time while hearing ascending beeps and a
voice prompt, “Hello”. To power off the headset, press the Center Button and the (+) Button at the same time while hearing
descending beeps and a voice prompt, “Goodbye”.
4.2.2 Handlebar Remote
To power on the device, tap the Front Button and the blue LED will appear. To power off the device, press and hold the Front
Button and the Joystick for two seconds until red LED blinks.
4.3 Charging
You can charge the headset and the Handlebar Remote by connecting the supplied USB power & data cable into a
computer’s USB port or USB wall charger. You can use any standard micro USB cable to charge the units. You can also
charge them on the road using the cigarette charger. The charging LED turns red while charging and turns blue when fully
charged. It takes about 2.5 hours to be completely charged.
Note:
If you purchase the battery pack, sold separately, you can use the 2-Pin connector to Micro-USB Adapter for charging the
10R. You should connect the USB power & data cable first to the 2-Pin Connector to Micro-USB Adapter and then to the
battery pack in series.
4.4 Checking the Battery Level
4.4.1 LED Indicator
When the headset or the Handlebar Remote is powering on, their red LED flashes rapidly indicating the battery level.
4 flashes = High, 70~100%
3 flashes = Medium, 30~70%
2 flashes = Low, 0~30%
4.4.2 Voice Prompt Indicator
When you power on the headset, keep pressing the Center Button and the (+) Button simultaneously for about 3 seconds
until you hear three, high toned beeps. Then you will hear a voice prompt indicating the battery level. However, if you release
the buttons as soon as the headset turns on, you will not hear the voice prompt for the battery level indication.
4.5 Volume Adjustment
You can easily adjust the volume by moving the Joystick up or down. You will hear a beep when the volume reaches the
maximum or minimum level. The volume is set and maintained independently at different levels for each audio source even
To Next Page
Loading...
Need help?
General
