11 FM RADIO
11.1 FM Radio On/Off
To turn on the FM radio, press the Rear Button for 1 second until you hear a mid-toned double beep sound. You will then
hear a voice prompt, “FM on”. To turn off the FM radio, press the Rear Button for 1 second until you hear a voice prompt, “FM
off”. When you power it off, the 10R will remember the last station frequency. When you power it on, the last station
frequency will be playing.
11.2 Preset Stations
You can listen to preset stations while listening to the FM radio. Tap the Rear Button once to go upward to your next saved
preset station.
11.3 Seek and Save
“Seek” is the function that searches for station to station frequencies. To use the “Seek” function, please follow the procedure
below:
1. Move and hold the Joystick left or right for 1 second to search down or up the station dial.
2. If the tuner finds a station while searching frequencies, it stops the seek function.
3. To save the current station, press and hold the Front Button for 1 second until you hear a voice prompt, “Preset (#)”.
4. Move the Joystick up or down in order to select which preset number you want for that specific station. You can save up to
10 preset stations. (You may cancel the preset operation by waiting approximately 10 seconds. You will then hear “Save
preset cancelled”. You can also move the Joystick up or down until you hear “Cancel”. Tap the Front Button to confirm
cancellation. You will then hear “Save preset cancelled”).
5. To save the current station, tap the Front Button again. You will then hear a voice prompt, “Save preset (#)”.
6. To delete the saved station in the preset number, tap the Rear Button. You will then hear a voice prompt, “Delete preset
(#)”.
Note:
1. You can save FM stations to presets before using FM radio. Connect the 10R to your PC and open the Sena Device
Manager. It allows you to save up to 10 FM station frequency presets on the 10R settings menu. You may do the same
operation by using the Sena Smartphone App.
2. You can still answer an incoming phone call and intercom while listening to the FM radio.
11.4 Scan and Save
“Scan” is the function that automatically searches station frequencies, starting from the current frequency and up. To use the
scan function, please follow the procedures below:
1. Double tap the Rear Button. Then the current station frequency moves upward to find other station frequencies.
2. If the tuner finds a station, it stays at the station frequency for 8 seconds, then scanning to the next station frequency.
3. Scan function stops when you double tap the Rear Button again.
4. To save a station while scanning frequencies, tap the Rear Button when at that station. You will hear a voice prompt from
the 10R, “Save preset (#)”. The station will be saved as the next preset number.
5. All stations preset during “Scan”, will overwrite previously set stations.