5 PAIRING THE 10R WITH BLUETOOTH DEVICES
Before using the 10R Bluetooth headset with any other Bluetooth devices for the first time, you will need to pair them together.
You can pair the 10R with Bluetooth mobile phones, Bluetooth stereo devices such as MP3 players, or motorcycle specific
Bluetooth GPS navigation, and with other Sena Bluetooth headsets. The pairing operation is required only once for each
Bluetooth device. The headset remains paired with the devices and automatically reconnects to them when they are within
range. You will hear a high toned single beep and a voice prompt whenever the headset reconnects to the paired device:
“Phone connected” to a mobile phone, “Media connected” to a Bluetooth stereo device.
5.1 Mobile Phone Pairing - Mobile Phone, Bluetooth Stereo Device
1. To enter the voice configuration menu, press and hold the Front Button for 12 seconds until you hear the voice prompt,
“Configuration menu”.
2. Move the Joystick up or down until you will hear the voice prompt, “Phone pairing”.
3. Search for a Bluetooth device on your mobile phone. Select Sena 10R in the list of devices detected on the mobile phone.
4. Enter 0000 for the PIN. Some mobile phones may not ask for a PIN.
5. The mobile phone confirms that pairing has completed and the 10R is ready for use. You will hear the voice prompt, “Your
headset is paired”.
6. If the pairing process is not completed within three minutes, the 10R will return to stand-by mode.
Note:
1. If the Bluetooth connection between the headset and a mobile phone is disconnected, tap the Rear Button to recover the
Bluetooth connection immediately.
2. If the Bluetooth connection between the headset and a media player is disconnected, press the Joystick for 1 second to
recover the Bluetooth connection and play.
5.2 Second Mobile Phone Pairing - Second Mobile Phone, GPS, and SR10
Typical Bluetooth headsets can connect with only one HFP (Hands-Free-Profile) Bluetooth device such as mobile phone,
GPS, and Sena SR10, but second mobile phone pairing allows the headset to connect with two HFP devices simultaneously.
So, when you already have a mobile phone connected with the 10R, you can also pair and connect a second mobile phone or
other HFP devices.
1. To enter the voice configuration menu, press and hold the Front Button for 12 seconds until you hear the voice prompt,
“Configuration menu”.
2. Move the Joystick up or down until you hear the voice prompt, “Second mobile phone pairing”.
3. Search for Bluetooth devices on the HFP device. Select the Sena 10R in the list of the devices detected on the HFP device.
4. Enter 0000 for the PIN. Some HFP devices may not ask for the PIN.
5. The HFP device confirms that the pairing is completed and the 10R is ready for use. You will hear a voice prompt, “Your
headset is paired”.
Note:
1. If the GPS is also your preferred Bluetooth stereo music source, you can pair the GPS to the 10R by following the simple
procedure in section 5.1, “Mobile Phone Pairing - Mobile Phone, Bluetooth Stereo Device”.
To Next Page
Loading...
Need help?
General
