disabled if you are connected to intercom. If this feature is disabled, you have to tap the Center Button to answer an incoming
call.
13.8 Enabling/Disabling Voice Activated Intercom
If this feature is enabled, you can initiate an intercom conversation with the last connected intercom friend by voice. When
you want to start intercom, say a word such as “Hello” loudly or blow air into the microphone. If you start an intercom
conversation by voice, the intercom terminates automatically when you and your intercom friend remain silent for 20 seconds.
However, if you manually start an intercom conversation by tapping the Center Button, you have to terminate the intercom
conversation manually.
However, if you start intercom by voice and end it manually by tapping the Center Button, you will not be able to start
intercom by voice temporarily. In this case, you have to tap the Center Button to restart the intercom. This is to prevent
repeated unintentional intercom connections by strong wind noise. After rebooting the 10R, you can start intercom by voice
again.
13.9 Setting Intercom Vox Sensitivity
Tap the (+) Button or the (-)
Button
(1~5)
Tap the (+) Button or the (-) Button until you hear the voice prompt, “VOX sensitivity”. By tapping the Center Button, it will
lead you to the level adjustment mode. If you enter the mode, you will hear a prompt stating the current VOX sensitivity level.
You may adjust the VOX sensitivity level by tapping the (+) Button or the (-) Button. Level 5 is the highest sensitivity setting
and 1 is the lowest. After you have completed the setting, tap the Center Button to apply the changes.
13.10 Enabling/Disabling Voice Prompts
You can disable voice prompts by configuration setting, but the following voice prompts are always on.
To Next Page
Loading...
Need help?
General
