Sena 20S - Voice Activated Phone Answering

20S
46
21.7 Setting Motion Sensor Sensitivity
Voice Prompt
“Motion sensor sensitivity”
Factory Default High
Level Adjustment
Rotate the Jog Dial
(High/Low/Disable)
Apply Tap the Phone Button
Motion Sensor Sensitivity determines the sensitivity when you double
tap on the surface of the 20S to enter voice command mode. Rotate the
Jog Dial until you hear the voice prompt, “Motion sensor sensitivity”.
By tapping the Phone Button, it will lead you to level adjustment mode.
Default is at high, but you may change it to low, or disable the feature
by rotating the Jog Dial. After you have completed the setting, tap
the Phone Button to apply the changes. If this feature does not work
properly, disable this feature, and press on the Ambient Mode Button
to enter voice command mode.
21.8 Enabling/Disabling Voice Activated Phone Answering
Voice Prompt
“VOX phone”
Factory Default Enable
Enable Tap the Phone Button
Disable Tap the Jog Dial
If this feature is enabled, you can answer incoming calls by simply
saying a word loudly enough, unless you are connected to intercom.
For example, when you hear a series of beeps for an incoming call,
you can answer the phone by saying “Hello” or any other word loudly.
However, the VOX Phone feature does not work if you are connected
to intercom. This feature is enabled from the factory but can be
DISABLED THROUGH THE CONlGURATION MENU $EVICE -ANAGER OR THE
Sena Smartphone App. If this mode is disabled, you have to tap the
Jog Dial or the Phone Button to answer an incoming call.