Sena 20S - Remote Control Operation; Pairing with Handlebar Remote; Using the Handlebar Remote

20S
40
19 REMOTE CONTROL
You can remotely control the 20S via Bluetooth using the Handlebar
Remote (sold separately). This eliminates the need to take off your
hand for button operations. Your 20S and the Handlebar Remote must
be paired together before use.
19.1 Pairing with the Handlebar Remote
1. Turn on the 20S and the Handlebar Remote.
 0RESSTHE*OG$IALFORSECONDSTOENTERTHECONlGURATIONMENU
Rotate the Jog Dial until you hear a voice prompt saying, “Remote
control pairing”. Press the Phone Button to enter into Remote
#ONTROL0AIRINGMODEANDTHERED,%$WILLmASHRAPIDLYANDYOU
will hear multiple beeps. Please refer to section 21.16, “Remote
Control Pairing” for more details.
3. On the Handlebar Remote, press the Rear Button for 5 seconds
UNTIL ITS ,%$ mASHES RED AND BLUE 4HE 3 WILL AUTOMATICALLY
perform pairing with the Handlebar Remote in pairing mode. The
(ANDLEBAR2EMOTES,%$WILLmASHBLUEEVERYTWOSECONDSWHEN
they are successfully connected.
19.2 Using the Handlebar Remote
The 20S and the Handlebar Remote have button operations matched
as described in the following table. For example, if you move
the Joystick of the Handlebar Remote up or down, it will have an
equivalent effect of rotating your 20S Jog Dial. For details on remote
control button operations, please refer to the following tables or the
Handlebar Remote Quick Start Guide.