Sena 20S - Page 9

20S
9
English
2. Depending on the size and shape of your helmet, you may need
to change the thickness of the rubber pad between the clamp
PLATES9OUCANlNDTWOEXTRARUBBERPADSINTHEBOX4OINCREASE
the overall thickness, attach the thinner one to the original rubber
pad or replace the original rubber pad with the thicker one.
 0LEASEADJUSTTHEDIRECTIONOFTHEMICROPHONESOTHATTHElNSIDE
of the microphone is facing outward; away from your lips. You can
EASILYRECOGNIZEITBYTOUCHINGTHElNWITHYOURlNGERS
Fin
4. Place the helmet speakers along with the hook and loop fasteners,
centered to your ear, in the ear pockets of the helmet. If the helmet
has deep ear pockets, you can use the speaker pads to place the
speakers closer to your ears.
To enhance the audio quality, you can make use of the foam speaker
covers. Cover each speaker with the foam and attach the hook
fastener at the back of the speaker. Then place the speakers in the
helmet as described above. Foam covered speakers work most
effectively when they are slightly touching your ears.
Hook Fastener
Foam Speaker Cover