Servomex SERVOPRO - Rack Mounting; Rear Panel

SERVOPRO NOx Analyzers Page
15
RACK MOUNTING
The front panel is designed for mounting into a standard 19-inch rack enclosure. Holes are
located on the left and right side to allow the panel to be secured in the rack by screws.
Optional rack slides allow the analyzer to be pulled out of the rack enclosure for access.
REAR PANEL
The rear panel includes the following:
1. Rear-panel Power ON/OFF switch.
2. Power Entry module for power connection, power switch, fuse compartment.
3. Output connectors for analog outputs and remote functions.
4. TCP/IP connection to connect to network.
5. Serial connection to connect serial connector cable.
6. Zero Gas inlet for feeding hydrocarbon-free zero air or N
2
to the analyzer.
- Only present with optional solenoid valves; otherwise this port is plugged.
7. Ozone Air inlet for feeding hydrocarbon-free air or oxygen to the ozone generator.
8. Span Gas inlet for feeding calibration gas to the analyzer.
- Only present in analyzers with optional solenoid valves; otherwise this port
is plugged.
9. Vent to exhaust from reaction chamber, ¼-inch (6mm) tube fitting.
10. Sample Gas Bypass outlet (vent) for exhaust of sample, ¼-inch (6mm) tube.