Servomex SERVOPRO - Maximum Verifying Error

SERVOPRO NOx Analyzers Page
78
MAXIMUM VERIFYING ERROR
→ → → → →
To access the Maximum Verifying Error screen, press from the Deviation Limits
menu.
 To set the allowable tolerances for different ranges, use the up or down arrow
to move the highlight to the field you intend to change.
 Press Enter to open the field to change the value in %.
 Press Enter again to close the field.
 Press to save your changes.
NOTE: Maximum Verifying Error is the allowable tolerance during the Verifying step
of sequenced calibration.