SERVOPRO NOx Analyzers Page
AUTOMATED CALIBRATION
→
→
→
The Automated Calibration menu offers two choices: Sequenced Calibration and
Sequenced Check of the existing calibration.
The Automated Calibration menu is accessed by pressing from the Calibration
menu. Sequenced means that the flow times of both zero and span gases are controlled
using a timer. See
AutoCal Timing located in the Calibration Setup menu.
If a manually initiated sequenced calibration or sequenced calibration check is
selected, it will apply only to the range that is currently in use. (Each additional
NOTE: An automated calibration is a timed zero calibration immediately followed by
a timed span calibration.
NOTE: An automated calibration should not be attempted before manual zero and
span calibrations have been
To Next Page
Loading...
