SERVOPRO NOx Analyzers Page
STARTUP AND SHUTDOW N
Before using the analyzer, make sure the external plumbing and wiring have been
connected correctly as shown in the Rear Panel description. All connections should be
leak-tight, and inlet pressure settings adjusted as previously described.
Turn on the Power switch on the analyzer’s rear panel. After a short delay, the digital
display should illuminate. If the display does not come on, check the power source and
the fuse. If the problem persists, call SERVOMEX Technical Support.
Refer to the
Using the Keypad section and review the complete Operator’s Manual for
detailed instructions for proper setup and operation of the SERVOPRO NOx.
NOTE: Make sure the proper connections for the vents for the reaction chamber and
sample have been made prior to powering on the analyzer, since ozone will be flowing
from these vents.
To Next Page
Loading...
