Servomex SERVOPRO - Maximum Calibration Error

SERVOPRO NOx Analyzers Page
77
MAXIMUM CALIBRATION ERROR
→ → → → →
Each range has its own set of Absolute and Relative tolerances. The deviations must be
inside these tolerances to accept a calibration. To access the Maximum Calibration
Error screen, press from the Deviation Limits menu.
 To navigate between fields, use the up or down arrow to move the
highlight to the field you intend to change.
 Press Enter to open the field to change the allowable tolerance in %.
 Press Enter again to close the field.
 Press to save your changes.
 Absolute Deviation is used to compare the factory-set calibration to the current
calibration.
 Relative Deviation compares the current calibration to the previous calibration.
NOTE: Maximum Calibration Error is used by the operator to define the maximum
acceptable tolerances for Absolute and Relative deviations.