Servomex SERVOPRO - Page 73

SERVOPRO NOx Analyzers Page
72
AUTO CALIBRATION/CHECK
→ → → →
To access the Auto Cal/Check menu, press from the Calibration Setup menu. The
current setting is shown on the upper-right corner of the screen.
Press to set the analyzer Auto Cal/Check parameter to Calibrate (Cal). The setting
will be saved automatically.
 The analyzer returns to the Calibration Setup menu.
 The Calibration Setup menu now shows the current setting on the right side of the
screen after the (. . .).
 Example: AutoCal/Check . . . Cal.
Press to set the analyzer Auto Cal/Check parameter to Check. The setting will be
saved automatically.
 The analyzer returns to the Calibration Setup menu.
NOTE: Auto Calibration/Check lets the operator select whether the analyzer actually
calibrates, or performs a check of the calibration.