Sharp AJ-6020 - Driver Installation for Windows NT 4.0

32
INSTALLING THE "AJ-6000 SERIES DRIVER"
Installing onto Windows 2000 (Parallel interface)
1
Make sure that the unit is connected to your computer.
2
Turn on the unit, and then turn on your computer.
On this step, "Found New Hardware Wizard" will appear.
3
Click the "Next" button.
4
Insert the supplied CD-ROM into your CD-ROM drive.
5
Check the radio button for "Search for a suitable driver for my
device (recommended)", and then click the "Next" button.
6
Select the "Specify a location", and then click the "Next" button.
7
Type "D:\DRIVERS\MFP-PS\ENGLISH\WIN2000" and click the
"OK" button.
(Change "D" to correspond to the letter of your CD-ROM drive.)
8
Click the "Next" button.
9
Click the "Finish" button.
10
Restart your computer.
You have completed the installation of the AJ-6000 series driver.
If "Found New Hardware Wizard" does not appear, go to "Installing through Setup".
(See page 36)
To install the driver successfully, be sure to select the "Specify a location".
After installing the AJ-6000 series driver, install AJ-6000 series software referring
to page 37.