AR-M207 M165 M162 SIMULATIONS 7-25
26 74 Total counter display change setting
Used to set whether the scanner counter value is added to the total counter display in the key operator
program.
[CA] key: Exits the simulation mode.
[Interruption] key: Shifts to the sub code input window.
Default:
0 (Scan counter not
added)
30 01 Paper sensor status display
Used to display the list of paper sensor status on the LCD. An active sensor is highlighted.
The display items and corresponding sensors are shown below.
When a multi-stage cassette is not installed as an option, the corresponding sensor name is not displayed.
41 01 Document size detection photo sensor check
Used to check the operation of the document sensor.
When this simulation is executed, the status of the document sensor is displayed.
An active sensor display is highlighted.
* For AB series, PD1-PD5; for inch series, PD1 - PD4.
Main
code
Sub
code
Contents Remark
Sim26-74 ADD COUNT
1:ADD SCAN CNT
[ 0- 1]
0
0
0 : Scan counter not added
1 : Scan counter added
Display : Corresponding sensor
POUT : Paper exit sensor
DPX : DUPLEX sensor
PIN : Paper entry sensor
MBEMP : Manual feed paper sensor
C1EMP : No. 1 tray paper sensor
C2EMP : No. 2 tray paper sensor
C3EMP : No. 3 tray paper sensor
C4EMP : No. 4 tray paper sensor
C2PSS : No. 2 tray paper feed sensor
C3PSS : No. 3 tray paper feed sensor
C4PSS : No. 4 tray paper feed sensor
DRST : New drum sensor (AL model only)
Sim30-1 SENSOR
POUT DPX PIN
MBEMP C1EMP C2EMP
C3EMP C4EMP C2PSS
C3PSS C4PSS DRST
Sim41-1 PD SENSOR
OCSW PD1 PD2
PD3 PD4 PD5
OC cover open/close sensor status Document sensor status
OCSW Open Close PD1 - PD5 Document NO Document
YES
Highlighted Normal display Normal display Highlighted
[07]SIMULATIONS.fm 25 ページ ２００４年１１月１７日 水曜日 午後１２時１１分
To Next Page
Loading...
