1-69
BEFORE USING THE MACHINE
REPLACING THE TONER COLLECTION
CONTAINER
The toner collection container collects excess toner that is produced during printing. When the toner collection container
becomes full, "Replace used toner container." will appear. Follow the procedure below to replace the toner collection
container.
1
Open the front cover.
2
Release the used toner collection
container.
Move the lock of the toner collection container to the release
position.
Release the lock of the toner collection container and let it fall
forward as far as it will go as shown in the figure.
Keep the replacement cleaner that has not been used.
Store it on the left of the new toner collection container.
3
Remove the toner collection container.
Hold the box by both hands and lift it up slowly.
If the toner collection container falls too far forward, it will not be
possible to remove it. (Remove the box when it is at an angle of
about 30 degrees.)
To Next Page
Loading...
