1-3
BEFORE USING THE MACHINE
This section provides basic information about the machine. Please read this chapter before using the machine.
PART NAMES AND FUNCTIONS
EXTERIOR
(1) Automatic document feeder (Reversing single pass
feeder)
*
This automatically feeds and scans multiple originals. Both
sides of 2-sided originals can be automatically scanned.
+
PLACING THE ORIGINAL (page 1-40)
(2) Front cover
Open this cover to switch the main power switch to "On"
or "Off" or to replace a toner cartridge.
+
TURNING THE POWER ON AND OFF (page 1-15)
+
REPLACING THE TONER CARTRIDGES (page
1-66)
(3) Output tray (centre tray)
Output is delivered to this tray.
(4) Operation panel
This is used to select functions and enter the number of
copies.
+
OPERATION PANEL (page 1-8)
(5) Document cover*
This holds down the original.
(6) Finisher
*
(DX-2500N only)
This can be used to staple output. A punch module can
also be installed to punch holes in output.
+
FINISHER (page 1-46)
* Peripheral device.
BEFORE USING THE MACHINE
When a finisher is installed
When a Document cover is
installed
To Next Page
Loading...
