Sharp LC-32LB261U User Manual

36
LC-32LB261U Sharp 32" LED TV
Using the remote
control
Installing remote control batteries
1 While pressing the release latch on the back of the remote
control, lift the battery compartment cover off of the
remote control.
2 Insert two AAA batteries into the battery compartment.
Make sure that you match the + and – symbols on the
batteries with the + and – symbols in the battery
compartment.
3 Replace the battery compartment cover.
Aiming the remote control
• Point the remote control towards the remote sensor on
the front of your TV. For the location of the remote sensor,
see “Front” on page 8.
Cautions
• Batteries should not be exposed to
excessive heat, such as sunshine, heat
registers, or fire.
• Battery chemicals can cause a rash. If the
batteries leak, clean the battery
compartment with a cloth. If chemicals
touch your skin, wash immediately.
• Make sure that batteries are disposed of
correctly. Do not burn or incinerate.
Notes
• Do not mix batteries of different types.
• Do not mix old and new batteries.
• Remove batteries when the charge is
depleted.
• If the remote control is not going to be
used for an extended period of time,
remove the batteries.

Sharp LC-32LB261U Specifications

General

Screen Type	led
Wall Mount	100mm x 100mm
Screen Size	31.5 inches, 32 inches
Refresh Rate	60hz
Brightness	180 candela per square meter
Speakers Output	10 watts
USB Ports	1
RF Antenna	yes
Headphones Output	yes
Digital Optical Audio Outputs	1
Component Video Inputs	1
Composite Video Inputs	1
DVI	1
3D	no
Power Consumption	81 kilowatt hours
Depth with Stand	6.5 inches
Height with Stand	18.38 inches
Width with Stand	28.63 inches
Net Weight with Stand	11.3 pounds
Depth without Stand	2.5 inches
Height without Stand	17.13 inches
Net Weight without Stand	10.6 pounds