39
LC-32LB261U Sharp 32" LED TV
9 Press W X or ENTER to highlight Hour, Minute, or the
AM/PM field, then press S or T adjust the option. When
you are finished, use the arrow buttons to highlight Next,
then press ENTER.
10 Press
S or T to highlight a video input source, then press X
to move to the label area.
11 Press
S or T to highlight a preset label or Custom.
12 If you select a preset label, press ENTER. The video input
box on the left is selected so you can label a different video
input source.
OR
If you select Custom, press ENTER, then press
S or T to
enter the first character in your custom label, then press X
to move to the next character position. Use the arrow
buttons to enter additional characters or to move from
character to character. You can enter 12 characters (letters
or numbers). When you have finished creating your label,
press ENTER. The video input box on the left is selected so
you can label a different video input source.
13 Repeat Steps 10 through 12 to label additional video input
sources.
14 When you have finished creating input labels, use the arrow
buttons to highlight Next, then press ENTER.
Finish the wizard
15 Press
S or T to highlight Cable/Satellite Box, Cable from
the wall, or Antenna, then press ENTER.
•If you select Cable/Satellite Box, a screen opens that
shows you the ways you can connect the box.
Press ENTER.
•If you select Cable from the wall or Antenna, your TV
starts scanning for channels and displays a progress
screen. The scan may take several minutes.
When a message tells you that setup is complete, press
ENTER to close the menu.
16 Press ENTER to close the wizard. If you selected:
• Cable from the wall or Antenna, your TV tunes to the
first channel it found in the scan.
• Cable/Satellite box, press INPUT to open the INPUT
SOURCE list, press
S or T to select the video input (HDMI,
Component, or AV ) you connected the box to, then press
ENTER. Your TV switches to the input you selected.
Note
You can press EXIT, or highlight Skip and
press ENTER, to stop the auto channel
search, but you will need to run the auto
channel search again to create a channel
list.
To Next Page
Loading...
Need help?
General
