e
(Mute)
Using
e
(Mute)ontheremotecontrolunit
to mute the
current sound output.
1
2
• Mute will be cancelled after 30 minutes. However,
the TV will not suddenly output loud sound as the
volume level will be set to 0 automatically. Increase
the volume level by pressing
VOL
k
.
Press
e
(Mute)
.
• Thesoundissilenced.
• “
” is displayed while the mute function is on.
Press
e
(Mute)
again within 30 minutes to
cancel the mute.
• Within30minutes,thevolumelevelreturnstothe
previoussetting.
28
Watching TV
SLEEP
Autopower-offatadesignatedtime.Thisfunctionis
convenientlyusedwhen,forinstance,goingtobed
whilewatchingTV.
Signal Mode switch
When receiving a
stereo signal
NICAMSTEREO,MONO
When receiving a
bilingual signal
NICAMCHA,NICAMCHB,NICAM
CHAB,MONO.
When receiving a
monaural signal
NICAMMONO,MONO
MPX
You can switch between multiple audio modes
when watching a multiple audio or stereo broadcast
programme.
EachtimeyoupressMPX the mode switches as
follows.
In the NICAM TV broadcasts
In the TV mode of A2 TV broadcasts
Signal Mode switch
When receiving a
stereo signal
STEREO,MONO
When receiving a
bilingual signal
CHA,CHB,CHAB
When receiving a
monaural signal
MONO
1
2
Press
SLEEP
.
• Remainingtimedisplayswhensleeptimerhas
been set.
Eachtimeyoupress
SLEEP
, the remaining
time switches as shown below.
0 hr. 30 min. 1 hr. 00 min. 1 hr. 30 min.
2 hr. 30 min. 2 hr. 00 min.
Off
• Whenthetimehasbeenset,countdownautomatically
starts.
• Fiveminutesbeforethepresetoftimeexpires,the
remaining time displays each minute.
• Select“Off”bypressing
SLEEP
to cancel the sleep timer.
INFO
WhilewatchingDTVyoucanchecktheextended
programme information on the screen using INFO on
the remote control.
•YoucancancelthisinfobypressingINFO again.
LX360H_en_ID6-201400313.indd 28 2014/3/15 10:12:53