MX-5001N SIMULATION 6 – 1
MX-5001N
Service Manual
[6] SIMULATION
1. General (Including basic operations)
The simulation mode has the following functions, to display the
machine operating status, identify the trouble position and causes
in an earlier stage, and make various setups and adjustments
speedily for improving the serviceability of the machine.
1) Various adjustments
2) Setting of the specifications and functions
3) Canceling troubles
4) Operation check
5) Counters check, setting, clear
6) Machine operating conditions (operation hysteresis), data
check, clear.
7) Various (adjustments, setting, operation, counters, etc.) data
transport.
The operating procedures and displays depend on the design of
the operation panel of the machine.
A. Basic operation
(1) Starting the simulation
* Entering the simulation mode
1) Copy mode key ON → Program key ON → Asterisk (*) key ON
→ CLEAR key ON → Asterisk (*) key ON → Ready for input of
a main code of simulation
2) Entering a main code with the 10-key → START key ON.
Or select a main code with the SIM key on the touch panel.
3) Entering a sub code with the 10-key → START key ON.
4) Select an item with the scroll key and the item key.
5) The machine enters the mode corresponding to the selected
item. Press [START] key or [EXECUTE] key to start the simu-
lation operation.
* Canceling the simulation mode to return to the normal mode
1) Press [CA] key.
(Note for the simulation mode)
Do not turn OFF the power switch on the operation panel when the
machine is in the simulation mode. If the power switch should be
turned OFF in the simulation mode, a malfunction may be resulted.
In this case, turn OFF/ON the main power source.
To Next Page
Loading...
