MX-5001N LSU SECTION H – 5
B. Others
(1) LSU shutter solenoid 1
1) Remove the rear cabinet.
2) Remove the MC PWB.
3) Remove the screw and disconnect the connector, and remove
the filter box unit.
4) Remove the screw and remove the duct harness cover. Dis-
connect the connector.
5) Remove the screw, and remove the ozone air inlet duct A.
6) Remove the screw, and remove the ozone air inlet duct B.
7) Remove the LSU.
8) Disconnect the connector and remove the screw, and remove
the LSU shutter solenoid unit.
* When installing, insert the projected section (A) of the sole-
noid arm into the hole in the lever link arm.
9) Remove the screw and the spring, and remove the LSU shut-
ter solenoid.
* When installing, engage the solenoid pin (A) with the shutter
lever arm.
Parts
a LSU shutter solenoid 1
a
A
A
To Next Page
Loading...
