Sharp MX-5000N

MX-5001N MAINTENANCE 8 – 16
E. Transfer section
✕: Check (Clean, replace, or adjust according to necessity.) {: Clean S: Replace U: Adjust ✩: Lubricate
No. Part name
When
calling
150
k
300
k
450
k
600
k
750
k
900
k
1050
k
1200
k
1350
k
1500
k
1650
k
Remark/Refer to the
Parts Guide.
Block/Item No.
(Only the replacement
parts are described.)
1 Primary transfer
cleaner blade
Mechanical
parts
- ✕ S ✕ S ✕ S ✕ S ✕ S ✕ (P/G No.: [25]-18)
2 Primary transfer belt
drive gear
- ✕ S ✕ S ✕ S ✕ S ✕ S ✕ (P/G No.: [27]-13)
3 Intermediate transfer
belt
- ✕ S ✕ S ✕ S ✕ S ✕ S ✕ (P/G No.: [26]-1)
4 Primary transfer belt
drive roller
- ✕ { ✕ { ✕ { ✕ { ✕ { ✕
5 Belt CL brush - ✕ { ✕ { ✕ { ✕ { ✕
{ ✕
6 Primary transfer belt
follower roller
- ✕ { ✕ { ✕ { ✕ { ✕ { ✕
7 Primary transfer belt
tension roller
- ✕ { ✕ { ✕ { ✕ { ✕ { ✕
8 PTC opposed roller - ✕ { ✕ { ✕ { ✕ { ✕ { ✕
9 Primary transfer roller - ✕ S ✕ S ✕ S ✕ S ✕ S ✕ (P/G No.: [27]-9, [28]-42)
10 PTC unit - ✕ S ✕ S ✕ S ✕ S ✕ S ✕ (P/G No.: [20]-502)
11 Secondary transfer
idle gear
- ✕ S ✕ S ✕ S ✕ S ✕ S ✕ (P/G No.: [29]-6)
12 Secondary transfer
belt follower roller
- ✕ { ✕ { ✕ { ✕ { ✕ { ✕
13 Secondary transfer
belt
- ✕
S ✕ S ✕ S ✕ S ✕ S ✕ (P/G No.: [30]-21)
14 Secondary transfer
belt drive roller
- ✕ { ✕ { ✕ { ✕ { ✕ { ✕
15 Secondary transfer
idle shaft
- ✕ { ✕ { ✕ { ✕ { ✕ { ✕
16 Secondary transfer
roller
- ✕ S ✕ S ✕ S ✕ S ✕ S ✕ (P/G No.: [30]-6)
17 Pro-reg sensor - {{{{{{ {{{{{
18 Transfer cleaner seal
F/R
- ✕✕✕✕✕✕✕✕✕✕✕
19 Primary transfer toner
reception seal
- ✕✕✕✕✕✕✕✕✕✕✕
20 Secondary transfer
backup blade
- ✕✕✕✕✕✕✕✕✕✕✕