Sharp MX-5000N

MX-5001N SCANNER SECTION E – 3
3. Disassembly and assembly
A. Scanner unit
1) Remove the upper cabinet rear cover and the upper cabinet
rear.
2) Remove the table glass and the SPF glass.
3) Remove the upper cabinet right and the upper cabinet left..
4) Disconnect the connector, and remove the snap band.
5) Remove the screw, and remove the scanner unit.
(1) Scanner lamp/CL inverter PWB
1) Remove the SPF glass (A). Remove the glass holder (B) and
the table glass (C).
2) Shift the lamp unit to the right end. Loosen the screw, and
remove the wire.
Parts
a Scanner lamp
b CL inverter PWB
c CCD unit
d Scanner motor
e Document detection light receiving PWB
f Document detection light emitting PWB
f
d
e
b
a
c
1
2
3
A
B
C
2
2
1
3