Sharp MX-5000N

MX-5001N SCANNER SECTION E – 4
3) While rotating the lamp unit, lift it. Remove the harness holder
and the flat cable, and remove the lamp unit.
4) Disconnect the connector, and remove the lamp.
5) Remove the CL inverter PWB.
(2) CCD unit
1) Remove the dark box cover. Disconnect the connector, and
remove the CCD unit.
(3) Scanner motor
1) Remove the upper cabinet rear cover and the upper cabinet
rear.
2) Disconnect the connector and remove the scanner motor.
(4) Document detection light receiving PWB
1) Remove the operation base plate.
2) Disconnect the connector, and remove the document detection
light receiving PWB.
2
1
3
2
1
1
2